Access Control/Wiring of the Reader and Controller C-4MA

☰ Navigation Menu ▾

• How-To Guides ▾
  • Cameras ▸
    • IPC
    • LumiLuxLite
    • PTZ
    • Specialty
    • Direct-to-Cloud
    • Analog
  • Recorders ▸
    • NVR
    • DVR
  • IP Speaker
  • Access Control ▸
    • C-2PA
    • C-4MA
    • Video Doorbell
    • Facial Recognition Terminal
  • LumiCloud ▸
    • Basic Use
    • Recorders
    • Direct-to-Cloud Cameras
    • Access Control
    • Network Switches
  • Networking ▸
    • Access Point
    • Network Switches
    • Coax Extender
  • Off Grid ▸
    • LumiGuardian
    • LumiWatch
  • Software ▸
    • Computer Software ▸
      • LumiCenter
      • LumiPlayer
      • LumiUtility
      • LumiViewer
    • Mobile Software ▸
      • LumiCloud
      • LumiPartner
      • LumiViewer
  • 3rd Party Integration

• How-To Videos ▾
  • Cameras ▸
    • IPC
    • PTZ
  • Recorders ▸
    • NVR
  • Access Control
  • Off Grid ▸
    • LumiGuardian
  • LumiCloud ▸
    • LumiCloud Portals
    • LumiCloud for Network Switches
  • Software ▸
    • LumiCenter

• Firmware & Data Sheets ▾
  • Cameras ▸
    • IPC
    • PTZ
    • Specialty
    • Direct-to-Cloud
    • Analog
  • Recorders ▸
    • NVR
    • DVR
  • Kits
  • IP Speaker
  • Access Control
  • Networking
  • Off-Grid ▸
    • LumiGuardian
    • LumiWatch

• Software Downloads ▾
  • Computer Software ▸
    • LumiCenter
    • LumiPlayer
    • LumiUtility
    • LumiViewer
  • Mobile Software ▸
    • LumiCloud
    • LumiPartner
    • LumiViewer

• Product Selector ▾
  • IP Cameras
  • HD Analog
  • NVR
  • DVR
  • Accessories

Contact Support

Wiring of the Reader and Controller

Description

This tutorial will go over how to wire reader to access control.

Prerequisites

• Access control and readers

Step by Step Instructions

1. In the following wiring example, a reader is connected to access control.

2. For RS485 Match the wires of the reader and connect them to the corresponding contacts of the access control.
Purple = 485A
Yellow = 485B
Brown = LED1
Blue = CASE
Black = GND
Red = 12V

3. For Wiegand Match the wires of the reader and connect them to the corresponding contacts of the access control.
Green = Data 0
White = Data 1
Brown = LED1
Blue = CASE
Black = GND
Red = 12V

Note: For third-party readers, Wiegand connections are supported.